Simple, cheap DIY Go-Getter Tool
Moderators: richardh08, Boophoenix, Lloyd
Simple, cheap DIY Go-Getter Tool
"If you don't learn anything, what's the point?"
Re: Simple, cheap DIY Go-Getter Tool
Ok, so here's how they work...
Simple 32 x 12mm TT mix go-getters made using my cardboard tube and knitting needle tooling, launched from 15mm ID rocket motor tubes in a little 4-shot cake. I really like the effect!
So cheap, so effective. What's not to like about this?
http://youtu.be/tEyke5Mt75E
Simple 32 x 12mm TT mix go-getters made using my cardboard tube and knitting needle tooling, launched from 15mm ID rocket motor tubes in a little 4-shot cake. I really like the effect!
So cheap, so effective. What's not to like about this?
http://youtu.be/tEyke5Mt75E
"If you don't learn anything, what's the point?"
- richardh08
- Site Admin
- Posts: 2226
- Joined: Wed Aug 07, 2013 1:54 pm
- Location: Bedfordshire
Re: Simple, cheap DIY Go-Getter Tool
Just as a side-note: shots 1, 3 and 4, I got the go-getter core aligned 'properly'. Shot 2, it was accidentally at a slight angle to the axis of the go-getter, hence the whirring effect. I think I actually prefer this, so I might do it this way deliberately in future!
"If you don't learn anything, what's the point?"